Technical Specifications:
- Fully bus-powered USB 3.0 SuperSpeed Software Defined Radio
- Portable, handheld form factor: 5" by 3.5"
- Extensible gold plated RF SMA connectors
- 300MHz - 3.8GHz RF frequency range
- Independent RX/TX 12-bit 40MSPS quadrature sampling
- Capable of achieving full-duplex 28MHz channels
- 16-bit DAC factory calibrated 38.4MHz +/-1ppm VCTCXO
- On-board 200MHz ARM9 with 512KB embedded SRAM (JTAG port available)
- On-board 40KLE or 115KLE Altera Cyclone 4 E FPGA (JTAG port available)
- 2x2 MIMO configurable with SMB cable, expandable up to 4x4
- Modular expansion board design for adding GPIO, Ethernet, and 1PPS sync signal and expanding frequency range, and power limits
- DC power jack for running headless
- Highly efficient, low noise power architecture
- Stable Linux, Windows, Mac and GNURadio software support
- Hardware capable of operating as a spectrum analyzer, vector signal analyzer, and vector signal generator
El precio, eso es otra cosa.....Más info: http://www.nuand.com/bladeRF
Saludos.